Application guide

How to Apply Liquid Metal Shield

PolarTronix Liquid Metal Shield is designed for easy, precise application around sensitive components before applying liquid metal. Follow these steps to create a protective barrier and help reduce the risk of short circuits.

Application Steps

  1. 1

    Clean the Area

    Make sure the area around the chip or processor is clean and dry before applying the coating.

  2. 2

    Brush Around Components

    Use the integrated brush lid to apply Liquid Metal Shield around nearby capacitors, resistors, and exposed areas.

  3. 3

    Let It Cure

    Allow the coating to cure for approximately 30 minutes at 68–74°F (20–23°C) until the protective barrier is set.

  4. 4

    Apply Liquid Metal

    Once cured, apply liquid metal only to the intended surface area while the surrounding components remain protected.

Liquid Metal Shield applied around sensitive processor components

Application Tips

  • Apply only around sensitive components, not on the actual contact surface where liquid metal will be used.
  • Use a thin, controlled layer for better precision and a cleaner finished result.
  • Allow full curing before applying liquid metal for best protection.
  • Ideal for CPUs, GPUs, consoles, and other electronics using liquid metal cooling.